#1

Below are the steps to configure the DHCP pool on the ePMP hotspot, e400/500.

1. Network -> DHCP:-

Click onCreate poolwhich is available on the right hand side of the page and enter thePool ID.

Note: You may create upto 16 DHCP Pools.

1. png

2.配置网络Address range,Default gatewayandDNS.Savethe configuration.

2.PNG
2.PNG 737×336 95.8 KB

3.Add the devices to the bind list using the MAC address of a device in case you want to reserve a specific IP address for any specific device.

3.PNG
3.PNG 722×348 39.3 KB

4.Network -> VLAN:-

a. Addnew interfaceto Create VLAN interface

b. ConfigureIP Address( same as created as gateway on DHCP)

c. Check the "NAT" option to enable it so the client will get internet access.

4.PNG
4.PNG 722×256 71.1 KB

5.Configure -> WLAN:-

Create wirelessSSIDfor VLAN created.

5.PNG
5.PNG 736×294 91.9 KB

Now the client connect to this SSID will get IP Address from the pool configured on the device.

5 Likes
CnPILOT E500 and E600 as a router directly from the Internet Service Provide(ISP)
Configure Enterprise APs as Router Using cnMaestro
servidor dhcp
E400 setup Internet for wlan
MAC Bind List in cnPilot E400
CnPILOT E500 and E600 as a router directly from the Internet Service Provide(ISP)
CnPILOT E500 and E600 as a router directly from the Internet Service Provide(ISP)
#2

2 posts were split to a new topic:Facebook login from hotspot