还有更多要说的...
7. Boot scan-list
Why don't you show as scan list that device already scanned during boot-up? In most cases the SM is pointed in right direction. I'll need scanning only when there is no AP needed, usually is.On browser I get list of AP's as soon as I can log in into SM.
On browser I get device configured as I need in 1 minute.
When device boot up I connect to it via browser. Pick ap preferred AP from list, add password. Go to Network and change Network mode to NAT. Reboot. Done.
使用应用程序,我需要5分钟以上的前提。
我通过API到CNM所做的所有其他操作 - 发送配置文件,升级,批准...
8.将设备重新连接到AP
也许与应用程序无关,而是建议。
当我们更改需要无线重新连接的东西时,为什么不先尝试最后频率?SM已经以一定的频率连接到AP,如果没有AP,则进行完整扫描。当SM正常从AP下降时(可能有很多原因是更改AP频率的原因),但请尝试首先频率,然后进行完整扫描。
在大多数情况下,它将大大减少重新连接时间。
也许将此作为SM的选项?
9. Control the BACK button on phone
有时我不小心按下后面按钮。有时我需要重新开始。
扫描确实是屁股的痛苦。也将配置写入SM。如果我在SM期间向后按重新启动阶段,我需要再次编写配置才能完成安装。禁止或询问我们是否要回到此类步骤。
10.一直保持屏幕
保持按下屏幕以保持它很烦人。当应用程序运行时,请一直保持它。
It's great that you are giving effort to make app better but…
专注于我们从应用程序中真正需要的内容。扫描连接对齐。但是尽可能简单。
之后,给出越来越多的选择,但要清楚。允许我们自定义我们真正需要的东西。
Really, I only need scan/connect/align. Everything else is much easier via laptop or cnM/API.
Other functions are nice to have, but no crucial. Especially when you have lots of technicians. You want to keep it simple as possible.